Switching and metering – it will generate multiple elements). It will showĮvery function of the device as one single Element (In case a physical device has multiple functions – like This interface allows managing your smart home equipped with interconnected Z-Wave devices. Various screens of PC, pads or mobile phones. The design of the interface will adapt to the Your smart home can be controlled from different user interface. Release the button when the Status LED quickly flashes red indicating reset. To revert to the Factory default settings, press and hold the Reset button (inside the Z-box) for 10 seconds.
Important: Resetting the Z-box will delete all the settings, disconnect all Z-Wave devices and delete all of the Release the button when the LED quickly flashes red indicating reset. To reset the Network to the default settings, press and hold the Main button (on top of the Z-box) for 10 To install the batteries, pry open the lid of the Z-box at the notch in the back just above the cable ports. Hours to fully recharge 4 x 2400mA Ni-MH rechargeable batteries – please DON’T MIX different Z-Box provide trickle charge to recharge battery which is the safest charging technique, it takes approx. Operation for up to 6 hours (depend on battery capacity and application) when the power is out. The Z-box uses 4 Ni-MH AA Rechargeable batteries (not included) which allow the system to continue Using the cord provided, connect the Z-box to an electrical wall outlet. Instructions when installation is complete. Note-If a connection through the router is not available, there is an refer to the Dome App for step-by-step Using the LAN cable connect the Z-box to your router. Or storage options such as an EnOcean dongle, Bluetooth dongle, hard disk or any other USB device suitable
Setup the other users and give them access to the rooms. If you want to protect your login from other users inside the home, change the local This password is used for accessing the controller from outside the home. Got to setup (upper right corner) My Settings, remember your remote access ID and define your remote Login using the initial local default login (login: admin password: 123456) Input the IPĪddress into the address bar, press ENTER to enter the login page.（IP address：192.168.10.1） Use a web browser on your desktop PC or mobile internet device and go to login page. Power it up by plugging in the external power supplyĬonnect the z-box to your local router using a standard Ethernet cable
It needs only a few steps to get your Z-box up and running. Single devices as well as complete defined scenes and actions combining device functions within the network. This device is a control center (gateway) for Z-Wave home automation networks.
0 kommentar(er)
